Nov 28, 2025 Leave a message

Chapter Two: Function of Pulping

Chapter Two: The Function of Pulping

 

Pulping subjects fibers to shear force. Besides rubbing and dissolving the pulp, the changes in fibers during the pulping process can be regarded as: Under the pulping effect, the cell walls of the fibers shift and deform. Then, the P layer and S₁ layer are partially broken and the fibers are cut. Next, the fibers absorb water, swell and become fine fibers. In addition, fiber fragments are produced, causing the fibers to deform such as twisting, curling, compression and elongation. These changes directly affect the subsequent paper forming and the adaptability of the polyester drying screen. In fact, these effects and the change stages of fibers cannot be completely separated; they occur alternately. With different pulping conditions, the various effects and changes of fibers are also not the same. Moreover, different fiber forms will indirectly affect the service life and dehydration efficiency of Polyester dryer screens . The following is a detailed description.

 

The effect of pulping on fibers

The mechanical action of pulping causes the concentric layer of fine fibers in the S₂ layer to bend, shift and deform, increasing the gaps between the fine fibers and making it easier for water molecules to penetrate. The looseness of the fiber structure formed in this process needs to be reasonably matched with the mesh structure of the polyester drying screen to optimize the dehydration effect. Before the P layer is broken, the displacement and swelling of the S layer are both subject to certain restrictions. However, conversely, the displacement and swelling of the S₂ layer will make the fibers softer, promoting the breaking of the P layer and S₁ layer. Moreover, the increase in the degree of fine fiber formation on the fiber surface will reduce the adhesion of the slurry to the surface of the polyester drying screen. The displacement of the cell wall can be observed under a polarizing microscope, with a bright spot at the displacement site. Fibers that have not been pulping already have displacement bright spots. After pulping, the number of bright spots increases. As pulping proceeds, the bright spots gradually expand and become clearer. The displacement of fibers can be divided into three forms. The research suggests that for coniferous cysts, displacement mostly occurs at the location of the pectin rays.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry